WST FBM200A Instrukcja Operatora Strona 1

WS Technologies Inc. Beacon Monitor Operator’s Manual for model: FBM200A Version 1.00

6 Monitor Mode: The Monitor button will switch the screen to the Monitor mode. This is the normal mode for monitoring beacon

7 includes date and time of beacon burst, beacon 15 Hex ID, country code, beacon transmit frequency, receive level of beacon signal, and a comments f

8 Setup Mode: Clicking on the Setup Button will take you to the Setup mode. The setup menu has a selection of items. See details

9 Receiver Sensitivity The receiver sensitivity can be adjusted for each application. To receive beacon bursts from far away, set

10 Computer Alarms There are three alarm notification methods on the computer; Visual Alarm, Alarm Pop-up, and Audio Alarm. When

11 Alarm Pop-up A pop-up notification will appear in front of any application running on the computer. The Pop-up notification is closed by

12 Receiver Alarms Audio/LED/Relay Alarm The receiver audio alert will sound, the LED Indicator will flash red, and the relay contacts will

13 E-Mail Alerts Email alerts can be automatically sent to 2 email addresses. Check or un-check the boxes on the E-mail Alerts setup page to sui

14 SMS Alerts SMS Text Messaging alerts can be automatically sent to two numbers. Check or un-check the boxes on the SMS Alerts setup page to suit

15 Enter any addition information desired in the Message field. Click Apply to save the changes. Click Test to send a SMS message.

ii Information contained in this manual is subject to change without notice. Please consult the website at www.wst.ca for new Operator’s Manual updat

16 About Beacon Monitor The About Beacon Monitor screen shows Receiver Information including model number, serial number, Receiver firmware versi

17 RECEIVING BURSTS Once your system is setup you should always verify reception by transmitting a self test burst from a 406 MHz beacon. All burst

18 FREQUENTLY ASKED QUESTIONS Q: How do I manually check for software updates? A: Go to Setup > About Beacon Tester. Click on the Check for Upd

19 SPECIFICATIONS FBM200A SPECIFICATIONS  406 MHz Receiver Sensitivity -125 dBm  Out of Band Rejection (<400 MHz, >413 MHz) &

20 REGULATORY INFORMATION CANADA This Class B digital apparatus complies with Canadian ICES-003. USA Note: This equipment has been tested and

21 EUROPEAN UNION Supplier Name: WS Technologies Inc. Supplier Address: #2 – 215 Neave Road Kelowna, B.C. Canada V1V 2L9 Declare

22 WARRANTY INFORMATION WS Technologies Inc. (WST) warrants the products manufactured by WST to be free from defects in material and workmanship for

23 MISSION CONTROL CENTER (MCC) CONTACT INFORMATION In the event that you believe a Normal Mode (Live Burst) has been transmitted with sufficient po

24 NOTES Enter important data here for future reference. Product data FBM200A serial number: _________________ Date Purchased: ____________

iii CONTENTS INTRODUCTION ... 1 UNPACKING ...

iv

1 INTRODUCTION Thank you for choosing the FBM200 Beacon Monitor. This Operator’s Manual describes the installation and operation of the Beacon Monit

2 BEACON MONITOR Please read this Operator’s Manual to become familiar with the operation of the Beacon Monitor. Relay cont

3 Antenna Connection: Connect the 406 MHz antenna to the front panel RF IN connector. Optional Outdoor Antenna Installation: Alternatively, if yo

4 The Beacon Monitor Setup screen will appear. Click Next. If JavaTM is not installed on your computer, you will be prompted to inst

5 SETTING UP THE APPLICATION Click on the Beacon Monitor icon. The Beacon Monitor application will start and the following screen will be displayed: